logo

  1. Home
  2. Use Of Granulated Blast Slag As Replacement For Natural Sand

Use Of Granulated Blast Slag As Replacement For Natural Sand

In this paper granulated blast furnace slag is used as substitute for river sand in cement mortar and concrete to overcome the environmental problems created due to over mining. In this investigation in a cement mortar and concrete replacing natural sand by granulated blast furnace slag in a range of 20 40 6080 and 100.

Send Message Chat Online
  • use of blast furnace slag in road constructionppt

    use of blast furnace slag in road constructionppt

    Apr 28 2016 Use of blast-furnace slags as Sand and gravel for the construction of road beds Basic filler in asphaltconcrete mixtures for the construction of road and airport coatings Unroasted cement binder for reinforcing roadways and Preparing slow-setting concrete. Use of Blast Furnace Slag in Road Construction. 23.

  • ECO Friendly Concrete By Using Partial Replacement Of

    ECO Friendly Concrete By Using Partial Replacement Of

    granulated blast furnace slag for use in concrete mortar and grout 2006. 10 SIS Swedish Standard Institute 2008 SS 13 70 03 Concrete Usage of EN 206-1 in Sweden SIS. 11 Utgenannt P. 2004 The influence of ageing on the salt-frost resistance of concrete Ph.D. Thesis. Lund

  • Properties of Steel FiberReinforced AlkaliActivated Slag

    Properties of Steel FiberReinforced AlkaliActivated Slag

    Ground granulated blast furnace slag was employed as the main binder in the alkali-activated concrete mixes with a Blaine fineness of 4250 cm 2 g and a specific gravity of 2.70. Desert dune sand served as a sustainable fine aggregate.

  • Influence of Granulated Blast Furnace Slag and Cement on

    Influence of Granulated Blast Furnace Slag and Cement on

    Feb 24 2017 This study describes experimental results achieved by the use of granulated blast furnace slag GBFS and cement in stabilizing lithomargic clay for geotechnical applications. Soil was replaced by GBFS in percentages of 10 15 20 25 30 35 40 45 50 and cement of 2 4 6 and 8 by dry weight of soil is added.

  • PDF Properties of Foundry Sand Ground Granulated Blast

    PDF Properties of Foundry Sand Ground Granulated Blast

    Ground Granulated Blast Furnace Slag GGBFS and Bottom ash BA were used as source materials. From the preliminary studies the replacement of Foundry sand to Natural sand is taken as 5050. The density range was taken as 1800 Kgm3 2000 Kgm3 2200 Kgm3 and 2400 Kgm3.

  • Reinsertion of basic granulated blast furnace slag as

    Reinsertion of basic granulated blast furnace slag as

    Reinsertion of basic granulated blast furnace slag as replacement matter in mortars CARMEN Couto Ribeiro1a LUCIANA Dias Martins da Costa2b TADEU Starling3c PAULA Bamberg4d and JOANA Darc Silva Pinto5e 1Escola de Engenharia da Universidade Federal de Minas Gerais UFMG. Av. Ant nio Carlos 6627 - Bloco 01 - Sala 3305 - Pampulha - 31.270-901.

  • Replacing River Sand with Granulated Copper Slag in

    Replacing River Sand with Granulated Copper Slag in

    Granulated Copper Slag as a patial replacement for sand. r Fifteen concrete mixes with different proportions of Granulat-ed Copper Slag ranging from 0 for the control mix to 100 were considered. All the mixes were proportioned by the method of absolute volumes considering the specific grav ity of the constituent materials.

  • Influence of granulated blast furnace slag as fine

    Influence of granulated blast furnace slag as fine

    Influence of granulated blast furnace slag as fine aggregate on properties of cement mortar . The gradation of sand for preparation of mortar specimens was kept in accordance to the BIS 4031 part- 6 1988. The gradation of GBS was kept similar to the sand as per aforementioned code while making replacements for natural sand.

  • Effect of Granulated Blast Furnace Slag GBS Sand on

    Effect of Granulated Blast Furnace Slag GBS Sand on

    Effect of Granulated Blast Furnace Slag GBS Sand on Strength and Durability of Concrete . The results were obtained and compared with that of natural sand concrete. It is found that use of GBS sand will not reduce . natural sand concrete. 50 replacement of river sand with GBS sand gives better results in compression.

  • EFFECT OF GRANULATED BLAST FURNACE SLAG AS

    EFFECT OF GRANULATED BLAST FURNACE SLAG AS

    In this paper granulated blast furnace slag is used as substitute for river sand in cement mortar and concrete to overcome the environmental problems created due to over mining. In this investigation in a cement mortar and concrete replacing natural sand by granulated blast furnace slag in a range of 20 40 6080 and 100.

  • Geopolymer Bricks Using Iron Ore Tailings Slag Sand

    Geopolymer Bricks Using Iron Ore Tailings Slag Sand

    Feb 26 2020 2.1 Materials. A good brick earth which is available as a natural resource usually consist of 5060 of silica 2030 of alumina 5 of lime and 56 of oxide of iron .However for non-fired green bricks which can be made by using industrial wastes materials to be used includes iron ore tailings IOT slag sand fly ash and ground granulated blast furnace slag GGBS which can .

  • An Investigation on Combined Replacement of Cement

    An Investigation on Combined Replacement of Cement

    Future slag sand takes the place of natural sand. From this project work the optimum percentage of replacements are obtained as35 GGBS and 60 slag sand and as-45GGBS and 40 slag sand. Thus the combined effect of replacement reduces the use of cement and Natural sand to a large extent.

  • Characteristics of Blended Geopolymer Concrete Using

    Characteristics of Blended Geopolymer Concrete Using

    Jul 06 2020 Researchers throughout the world have studied the use of slag 13 quarry dust 14 granite fines 15-18 copper slag 19 20 etc. as replacement of conventionally used natural sand as fine aggregate for the manufacture of concrete.

  • Ground improvement Iron and steel slag products

    Ground improvement Iron and steel slag products

    The construction involved laying 60 cm of granulated blast furnace slag approximately 550000 m 3 on a 90-cm layer of marine sand in the Shin-Moji No. 1 coast project area and 90 cm of granulated blast furnace slag approximately 650000 m 3 on a 90-cm layer of marine sand in the No. 2 project area.

  • ECO Friendly Concrete By Using Partial Replacement Of

    ECO Friendly Concrete By Using Partial Replacement Of

    granulated blast furnace slag for use in concrete mortar and grout 2006. 10 SIS Swedish Standard Institute 2008 SS 13 70 03 Concrete Usage of EN 206-1 in Sweden SIS. 11 Utgenannt P. 2004 The influence of ageing on the salt-frost resistance of concrete Ph.D. Thesis. Lund

  • Properties of Steel FiberReinforced AlkaliActivated Slag

    Properties of Steel FiberReinforced AlkaliActivated Slag

    Ground granulated blast furnace slag was employed as the main binder in the alkali-activated concrete mixes with a Blaine fineness of 4250 cm 2 g and a specific gravity of 2.70. Desert dune sand served as a sustainable fine aggregate.

  • Influence of Granulated Blast Furnace Slag and Cement on

    Influence of Granulated Blast Furnace Slag and Cement on

    Feb 24 2017 This study describes experimental results achieved by the use of granulated blast furnace slag GBFS and cement in stabilizing lithomargic clay for geotechnical applications. Soil was replaced by GBFS in percentages of 10 15 20 25 30 35 40 45 50 and cement of 2 4 6 and 8 by dry weight of soil is added.

  • Reinsertion of basic granulated blast furnace slag as

    Reinsertion of basic granulated blast furnace slag as

    Reinsertion of basic granulated blast furnace slag as replacement matter in mortars CARMEN Couto Ribeiro1a LUCIANA Dias Martins da Costa2b TADEU Starling3c PAULA Bamberg4d and JOANA Darc Silva Pinto5e 1Escola de Engenharia da Universidade Federal de Minas Gerais UFMG. Av. Ant nio Carlos 6627 - Bloco 01 - Sala 3305 - Pampulha - 31.270-901.

  • A Study on Properties of Concrete Made with Processed

    A Study on Properties of Concrete Made with Processed

    In this study an attempt has been made to use granulated blast furnace slag from a local steel plant as a substitute to natural sand in normal concrete. The study mainly focusses on understanding the influence of different replacement ratios and suitability of slag replacement ratios higher than 50 in normal concrete.

  • PDF Study of Granulated Blast Furnace Slag as Fine

    PDF Study of Granulated Blast Furnace Slag as Fine

    The use of granulated blast furnace slag GBFS aggregates in concrete by replacement of natural aggregates is very promising concept because its impact strength is quite more than natural aggregate. Steel slag aggregates are already being used as aggregates in asphalt paving road m due to their mechanical strength stiffness porosity wear .